Work mode

Typical applications:

DC 12V Home lighting system

Electric door gate

Garage Door

Elevators

Motor reversing control

Remote control switch

Smart Home Kit

LED lighting

Fluorescent lamp

DC 12 DC Motor,RS360

Wiring Diagram 1:

DC 12V control circuit,Wiring diagram below. “LOAD” may be LED lights, fans, motors and other DC 12V

Wiring Diagram 2:

DC 1-48V OR AC 85-265V control circuit,Wiring diagram below(Note:If not DC 12V load, need another DC 12V power supply). “LOAD” may be LED lights, fans, motors and other DC AC equipment

Product Name :6x Transmitter + 1x Receiver kit RF 12v time delay relay 433m Wireless control

Packing list:

1 PCS433M DC 12V 2 Channel Multifunction Wireless Controller

6 PCS 433M Large Power 2 Button EV1527 Remote Control (USE 12V 27A battery,Batteries not included)

Technical indicators:

Operating voltage : DC 12V;DC 5V version can be customized

Operating Current : All relays close,about 14MA; one relay open,about 43MA;two relay open,about 71MA

Operating frequency : 433.92M; 315M version can be customized

Receiver sensitivity : -108dB;

Work mode : Non-locking (Momentary is defult),Self-locking (Toggle),Inter-locking (Latch), Delay;Each channel independently set the Work mode; 500,000 seconds maximum delay

Size(Including housing) : 75*54*28mm

Learning function (can works with EV1527 and PT2262 remote, can store 16 pcs different code remote );

Max load : 500W;

Normally, we would adapter remote control and receiver.

If the item you received has not been adapted Or you need to add accessories, Please follow the instructions below

Learning method and steps:

Under normal operating mode, LED will be lit, when receives a valid remote control (EV1527 / PT2262) button values, LED flashes

Clean code: press the button and held down, LED off, LED will light about 8 seconds later, clean code is completed (Note: After performing clean code previously stored remote control value does not exist)

Step 1 (into the learning mode): Press the button (about 1 second), LED off;

Step 2 (adapter channel 1): Then press the first button on the remote control, LED flashes four times off, then learning the first button value

Step 3 (Adaptation Channel 2): Then press the second button on the remote control, LED flashes four times brighter, then learned two key values

Use more details, please click here!